2024-07-10

前底板加长板

Repair Procedure

  1. Remove the original component.
    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
    or Factory Spot Welds
    Informational PurposesAn informational icon, calling your attention
    要检修以黑色圈出的点焊焊缝,请将中央车底面板的边缘(以红色显示)折回。
  2. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or High Strength Structural Rivets, 6.5 mm

    or Countersunk Rivets, 4.8 mm Short

    or Countersunk Rivets, 4.8 mm Long
    • A = 263 毫米。
    • B = 210 毫米。
    • C = 158 毫米。
    • D = 105 毫米。
    • E = 11 毫米。
  3. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  4. Install the new component or components.
  5. Perform any necessary post-repair operations.