2024-07-10

中央车底

Repair Procedure

  1. Remove the original component.
    or Factory Spot Welds
  2. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    A red X indicates a location where a factory-installed fastener is not being replaced.
    or Countersunk Rivets, 4.8 mm Long
    • A = 263 毫米。
    • B = 210 毫米。
    • C = 158 毫米。
    • D = 105 毫米。
    • E = 11 毫米。

    or Countersunk Rivets, 4.8 mm Short

    or High Strength Structural Rivets, 6.5 mm

    or Rivets, 4.8 mm

  3. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  4. Install the new component or components.
  5. Perform any necessary post-repair operations.