2024-07-17
车架前纵梁外件(区块)
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
Parts List
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- 拆卸前排座位剪力壁。
- Cut the original component at the indicated locations.
- Remove the original component.
-
如下所示,切割其中一个新车架前纵梁外部组件,制作新组件。
- B = 530 毫米
-
如下所示切割其中一颗车架前纵梁外部组件,制作加固板。
- C = 570 毫米
- D = 507 毫米
- Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
-
Install the new component or components.
将这些螺栓拧紧至 13 Nm。
-
Perform resistance spot
welding.
警告Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.警告Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
- 安装前排座位剪力壁。
- Perform any necessary post-repair operations.