2025-03-14

置物板加长板(后)

Repair Procedure

  1. Remove the original component.
    or Factory Spot Welds

    or Factory SPRs

  2. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or Structural Bulb Rivets, 6.5 mm

    or Countersunk Rivets, 4.8 mm Short

    or Flow Form Rivets, S18

    Informational PurposesAn informational icon, calling your attention
    在原始原厂 SPR 位置各面上安装一颗沉头铆钉,如下所示。
  3. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  4. Install the new component or components.
  5. Perform any necessary post-repair operations.