2024-07-17

后扭矩盒内部

Parts List

Quantity Description Image / Notes
1 ASY,RR TORQUE BOX,INR(后扭矩盒内部)
21 High Strength Structural Rivet, 6.5 mm
7 Structural Bulb Rivet, 6.5 mm
12 Structural Countersunk Rivet, 6.5 mm
1 Countersunk Rivet, 4.8 mm Short
1 Bolt Tesla 零件号 1063260-00-C。

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

  1. 拆卸后副框架上部横梁
  2. 拆卸第三排座椅横梁(上部)
  3. 拆卸踵板横梁
  4. Remove the original component.

    or Factory Spot Welds

    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.

    or Factory SPRs

    or Bolts

  5. Prepare for installation.
    or High Strength Structural Rivets, 6.5 mm
    • A = 33 毫米。
    • B = 9 毫米。
    • C = 15 毫米。
    • D = 6 毫米。
    • E = 33 毫米。

    or Structural Bulb Rivets, 6.5 mm

    or Structural Countersunk Rivets, 6.5 mm

    or Countersunk Rivets, 4.8 mm Short

    or Bolts

    or Installation Spot Welds

  6. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  7. Install the new component or components.
    将这些螺栓拧紧至 24 Nm。
  8. Perform resistance spot welding.

    or Installation Spot Welds

    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
  9. 安装踵板横梁
  10. 安装第三排座椅横梁(上部)
  11. 安装后副框架上部横梁
  12. Perform any necessary post-repair operations.