2026-08-09

Glove Box (Remove and Replace)

Correction code 1405010302 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

  • 2025-12-25: Added a step to open the glove box door using the touchscreen.

Torque Specifications

Table 1. Torque Specifications: Glove Box (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x4) securing glove box assembly to IP carrier
2.3 Nm (1.7 lbs-ft)
  • Torx T20 socket
 Reuse

Remove

  1. Remove the RH instrument panel end cap. See Instrument Panel - End Cap - Substrate - LH (Remove and Replace).
  2. For NA vehicles only: Remove the RH knee airbag. See Knee Airbag - RH (Remove and Replace).
  3. Release locking tab then release connector to disconnect glove box USB cable from car computer.
  4. Remove clip securing passenger footwell duct from glove box.
  5. Remove IP harness from glove box.
  6. Remove the screws (x4) that attach the glove box to the instrument panel carrier.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  7. On the touchscreen, tap Controls > Glovebox to open the glove box door.
  8. Release the clips (x8) and the locator pins (x3) that attach the glove box to the IP carrier, then carefully pull the glove box outward from the inner side.
    Note
    Use caution to avoid damaging the leather surface due to tight retaining clips.
  9. Disconnect the electrical connectors (x2) from the glove box.

Install

  1. Connect the electrical connectors (x2) to the glove box.
  2. Secure the clips (x8), locator pins (x3) and datum that attach the glove box to the instrument panel carrier.
  3. Install the screws (x4) that attach the glove box to the instrument panel carrier.
    2.3 Nm (1.7 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T20 socket
  4. Install clip securing passenger footwell duct to glove box.
  5. Install IP harness to glove box.
  6. Connect glove box USB cable to car computer.
  7. For NA vehicles only: Install the RH knee airbag. See Knee Airbag - RH (Remove and Replace).
  8. Install the RH instrument panel end cap. See Instrument Panel - End Cap - Substrate - LH (Remove and Replace).