2026-08-09

Camera - Interior (Remove and Install)

Correction code 1724010101 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Camera - Interior (Remove and Install)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screws (x2) that attach the interior camera to the camera upper cover
0.8 Nm (7 lbs-in)
  • Torx T10 bit
  • Digital Torque Screwdriver 0.10Nm - 2.0Nm (installation only)
 Replace 1919198-00-A

Remove

  1. Disconnect the LV battery power. See LV Power (Disconnect and Connect) (Modify).
  2. Remove the quad camera upper cover assembly. See Quad Camera Cover Upper (Remove and Replace).
  3. Remove and discard the screws (x2) that attach the interior camera to the upper camera cover, and then remove the interior camera from the upper camera cover.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T10 bit
    • Digital Torque Screwdriver 0.10Nm - 2.0Nm (installation only)