2026-08-09

Buckle - 2nd Row - LH (Remove and Replace)

Correction code 2005020602 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Buckle - 2nd Row - LH (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that secures the LH 2nd row buckle
40 Nm (29.5 lbs-ft)
  • Torx T50 socket
 Reuse

Remove

  1. Remove the 2nd row seat cushion. See Seat Cushion - 2nd Row (Remove and Replace).
  2. Pull up the clip bracket end, and then release the tab and slide backward to remove the connector from the clip bracket.
  3. Disconnect the LH rear seat belt buckle electrical connector.
  4. Remove the bolt that secures the LH 2nd row buckle, and then remove the buckle from the vehicle.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T50 socket

Install

  1. Install the bolt that secures the LH 2nd row buckle.
    40 Nm (29.5 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T50 socket
  2. Connect the LH rear seat belt buckle electrical connector.
  3. Slide forward to install the connector to the clip bracket until a click sound is audible.
  4. Install the 2nd row seat cushion. See Seat Cushion - 2nd Row (Remove and Replace).