2026-08-09

Crash Accel Sensor (Remove and Replace)

Correction code 2020010402 FRT 0.18 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Table 1. Torque Specifications: Crash Accel Sensor (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Bolt that attaches the front end module bracket crash accelerometer sensor
10 Nm (7.4 lbs-ft)
  • 10 mm socket
 Reuse

Remove

  1. Disconnect LV battery. See LV Power (Disconnect and Connect) (Modify).
  2. Remove the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  3. Disconnect the electrical connector from the front end module bracket crash accelerometer sensor.
  4. Remove the bolt that attaches the front end module bracket crash accelerometer sensor, and then remove the sensor.
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket

Install

  1. Position the sensor to the vehicle, and then install the bolt that attaches the front end module bracket crash accelerometer sensor.
    10 Nm (7.4 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm socket
  2. Connect the electrical connector to the front end module bracket crash accelerometer sensor.
  3. Install the underhood storage unit. See Underhood Storage Unit (Remove and Replace).
  4. Connect LV battery. See LV Power (Disconnect and Connect) (Modify).