2026-08-09

Noise Filter- +12V- FM - Antenna (Remove and Replace)

Correction code 2130010302 FRT 0.12 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See Ergonomic Precautions for safe and healthy working practices.

Torque Specifications

Table 1. Torque Specifications: Noise Filter- +12V- FM - Antenna (Remove and Replace)
Description Torque Value Recommended Tools Reuse/Replace Notes
Screw that secures the 12V noise filter
2 Nm (1.5 lbs-ft)
  • Torx T30 bit
  • Cordless Ratchet/Impact Driver
 Reuse The screw is self-contained to the filter.

Remove

  1. Remove the liftgate upper trim. See Liftgate Upper Trim (Remove and Replace).
  2. Remove the liftgate lower trim. See Liftgate Lower Trim (Remove and Replace).
  3. Disconnect the 12V noise filter from the backlite glass.
  4. Remove the screw that attaches the 12V noise filter to the vehicle, and then disconnect the electrical connector.
    Tip
    Use of the following tool(s) is recommended:
    • Torx T30 bit
    • Cordless Ratchet/Impact Driver

Install

  1. Install the screw that attaches the 12V noise filter to the vehicle, and then connect the electrical connector.
    2 Nm (1.5 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • Torx T30 bit
    • Cordless Ratchet/Impact Driver
  2. Connect the 12V noise filter to the backlite glass.
  3. Install the liftgate lower trim. See Liftgate Lower Trim (Remove and Replace).
  4. Install the liftgate upper trim. See Liftgate Upper Trim (Remove and Replace).