Pivot Clamp - Center Seatback - 2nd Row (5-Seat) (Remove and Replace)
Correction code
1305030702
FRT
0.12
NOTE: Unless
otherwise explicitly stated in the procedure, the correction code and its
associated FRT reflect all of the work required to perform this procedure,
including the linked procedures. Do not stack correction
codes unless explicitly told to do so.
NOTE: See Flat Rate Times to
learn more about FRTs and how they are created.
NOTE: See Personal Protection to make
sure you are wearing proper PPE when performing the procedure below.
NOTE: See Ergonomic Precautions for safe and healthy
working practices.
Torque Specifications
| Description | Torque Value | Recommended Tools | Reuse/Replace | Notes |
|---|---|---|---|---|
| Bolts (x2) that attach the pivot bracket clamps to the seat assembly |
 22 Nm (16.2 lbs-ft) |
|
Reuse |
Remove
- Remove the center 2nd row lumber bun. See Lumbar Bun - Center - 2nd Row (Remove and Replace).
-
Remove the bolts (x2) that attach the pivot bracket clamps to the seat
assembly.
TipUse of the following tool(s) is recommended:
- Torx T45 socket
-
Slide the pivot bracket clamps towards the center of the 2nd row center
seat frame, and then remove the clamps from the vehicle.
Install
-
Insert the pivot clamp at the center of the center frame, then slide the
clamps outwards to both ends of the frame.
NoteEnsure the clamps are properly positioned and aligned for fastener installation.
-
Install the bolts (x2) that attach the pivot bracket clamps to the seat
assembly.22 Nm (16.2 lbs-ft)TipUse of the following tool(s) is recommended:
- Torx T45 socket
- Install the center 2nd row lumber bun. See Lumbar Bun - Center - 2nd Row (Remove and Replace).