2025-12-23

Subwoofer (Remove and Replace)

Correction code 21212002 0.42 NOTE: Unless otherwise explicitly stated in the procedure, the above correction code and FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure wearing proper PPE when performing the below procedure. NOTE: See for safe and healthy working practices.

Remove

  1. Open all the doors and fully lower all the windows.
  2. Move the driver seat fully forward.
  3. Remove the 2nd row lower cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
  4. Remove the RH lower C-pillar trim. See .
  5. Remove the rear trunk load floor. See .
  6. Remove the front trunk load floor. See .
  7. Remove the trunk sill trim. See .
  8. Remove the RH trunk side trim.
  9. Remove the RH upper C-pillar trim. See .
  10. Remove the nuts and bolt that attach the amplifier to the body, and then carefully set the amplifier aside.
    5.4 Nm (4.0 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 2 in extension
  11. Disconnect the subwoofer electrical connector.
  12. Remove the nut and bolts that attach the subwoofer to the vehicle, and then remove the subwoofer from the vehicle.
    5.4 Nm (4.0 lbs-ft)
    Informational PurposesAn informational icon, calling your attention
    TIp
    Use of the following tool(s) is recommended:
    • 10 mm socket
    • 2 in extension

Install

Installation procedure is the reverse of removal.