13/11/2024 16:20:46

Crossmember Sealing Platter (Front)

Parts List

Quantity Description Image / Notes
1 PANEL - PLATTER SEALING CROSSMEMBER FRONT (Crossmember Sealing Platter – Front)
1 BUTYL FOIL PATCH 300X150x2MM (Butyl foil patch)

Tesla part number 1004969-00-A.

3 Structural Countersunk Rivet, 6.5 mm
8 Structural Bulb Rivet, 6.5 mm
4 Countersunk Rivet, 4.8 mm Long
11 Countersunk Rivet, 4.8 mm Short

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

  1. Remove the original component.
    or Factory Spot Welds
    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    Note
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
  2. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    A red X indicates a location where a factory-installed fastener is not being replaced.
    Informational PurposesAn informational icon, calling your attention
    Note
    Some rivet installation locations have been offset to avoid locations where removed fasteners are not being replaced.

    or Structural Bulb Rivets, 6.5 mm

    or Structural Countersunk Rivets, 6.5 mm

    or Countersunk Rivets, 4.8 mm Short

    or Countersunk Rivets, 4.8 mm Long

  3. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  4. Install the new component or components.
  5. Install the butyl foil patch as indicated to cover the installed fasteners.
  6. Perform any necessary post-repair operations.