Toeboard Outer
Correction code:
10101017102
10101011902
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair work required
to perform this procedure, including the linked Collision
Repair procedures. Do not stack Collision Repair
correction codes unless explicitly told to do
so. Add any associated mechanical procedures
needed to perform this procedure.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | Dash Crossmember | |
| 15 | High Strength Structural Rivet, 6.5 mm | |
| 7 | Countersunk Rivet, 4.8 mm Long |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Wheel Arch Liner - Front - LH (Remove and Replace).
- Remove the HV Battery (AWD) (Remove and Replace).
- Remove the Module - Body Controller - RH (Remove and Replace).
- Remove the Module - Body Controller - LH (Remove and Replace).
- Remove the Beam - Cross Car (LHD) (Remove and Replace).
- Remove the Pedal Assembly (LHD) (Remove and Replace).
- Remove the Carpet - Front - RH (Remove and Replace).
- Remove the Carpet - Front - LH (Remove and Replace).
- Remove the Center Console (Remove and Replace).
-
Remove the original component.
or Factory Spot Weldsor Drill through factory spot weldsNoteWhen drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
-
Prepare for installation.
or High Strength Structural Rivets, 6.5 mm
- A = 75 mm.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- Perform any necessary post-repair operations.
- Install the Center Console (Remove and Replace).
- Install the Carpet - Front - LH (Remove and Replace).
- Install the Carpet - Front - RH (Remove and Replace).
- Install the Pedal Assembly (LHD) (Remove and Replace).
- Install the Beam - Cross Car (LHD) (Remove and Replace).
- Install the Module - Body Controller - LH (Remove and Replace).
- Install the Module - Body Controller - RH (Remove and Replace).
- Install the HV Battery (AWD) (Remove and Replace).
- Install the Wheel Arch Liner - Front - LH (Remove and Replace).