Center Underbody
Correction code:
10100300102
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | MODULE - CENTER UNDERBODY STRUCTURE (Center Underbody) | |
| 24 | Countersunk Rivet, 4.8 mm Short | |
| 19 | Countersunk Rivet, 4.8 mm Long | |
| 18 | High Strength Structural Rivet, 6.5 mm | |
| 38 | Rivet, 4.8 mm |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Harness - Body - RH (LHD) (Remove and Replace).
- Remove the Harness - Body - LH (NA/EU) (Remove and Replace).
- Remove the Kit - Floor Mat - LHD (Remove and Replace).
- Remove the Carpet - Rear (Remove and Replace).
- Remove the Carpet - Front - RH (Remove and Replace).
- Remove the Carpet - Front - LH (Remove and Replace).
- Remove the Harness - HVAC (Remove and Replace).
- Remove the HV Battery (AWD) (Remove and Replace).
-
Remove the original component.
or Factory Spot Welds
-
Prepare for installation.
NoteA red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.
or Countersunk Rivets, 4.8 mm Short
or Countersunk Rivets, 4.8 mm Long- A = 52.8 mm
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Install the Console Mount (Front).
-
Install the Console Mount (Rear).
- Perform any necessary post-repair operations.
- Install the HV Battery (AWD) (Remove and Replace).
- Install the Harness - HVAC (Remove and Replace).
- Install the Carpet - Front - LH (Remove and Replace).
- Install the Carpet - Front - RH (Remove and Replace).
- Install the Carpet - Rear (Remove and Replace).
- Install the Kit - Floor Mat - LHD (Remove and Replace).
- Install the Harness - Body - LH (NA/EU) (Remove and Replace).
- Install the Harness - Body - RH (LHD) (Remove and Replace).