2026-04-27

Rear Frame Rail End Plate

Correction code: 10101815502 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	Brkt-Rr Rail to Bumper Plate (Rear Frame End Plate)
6	High Strength Structural Rivet, 6.5 mm
13	Structural Countersunk Rivet, 6.5 mm

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Seal - Trunk (Remove and Replace).
Remove the Bumper Beam - Rear (Remove and Replace).
Remove the Air Extractor (Remove and Replace).
Remove the Bracket - Tail Lamp - LH (Remove and Replace).
Remove the Bracket - Rear Wing - LH (Remove and Replace).
Remove the Striker - Trunk (Remove and Replace).
Remove the Front Carpet - Rear Trunk (Remove and Replace).
Remove the Trim - Side - Trunk - LH (Remove and Replace).
Remove the Rear Body Panel.
Remove the Rear Frame Rail to Lower Quarter Extension.
Remove the Trunk Floor Assembly (Side Panel).
Remove the original component.
or Factory Spot Welds
Prepare for installation.

Note
A red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.

or Structural Countersunk Rivets, 6.5 mm

or High Strength Structural Rivets, 6.5 mm
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Install the Trunk Floor Assembly (Side Panel).
Install the Rear Frame Rail to Lower Quarter Extension.
Install the Rear Body Panel.
Perform any necessary post-repair operations.
Install the Trim - Side - Trunk - LH (Remove and Replace).
Install the Front Carpet - Rear Trunk (Remove and Replace).
Install the Striker - Trunk (Remove and Replace).
Install the Bracket - Rear Wing - LH (Remove and Replace).
Install the Bracket - Tail Lamp - LH (Remove and Replace).
Install the Air Extractor (Remove and Replace).
Install the Bumper Beam - Rear (Remove and Replace).
Install the Seal - Trunk (Remove and Replace).