Crossmember Sealing Platter (Front)
Correction code:
10101017202
10101017302
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair work required
to perform this procedure, including the linked Collision
Repair procedures. Do not stack Collision Repair
correction codes unless explicitly told to do
so. Add any associated mechanical procedures
needed to perform this procedure.
Parts List
Quantity | Description | Image / Notes |
---|---|---|
1 | PLATTER SEALING CROSSMEMBER FRONT (Crossmember Sealing Platter – Front) | |
1 | BUTYL FOIL PATCH 300X150x2MM (Butyl foil patch) |
Tesla part number 1004969-00-A. |
3 | Structural Countersunk Rivet, 6.5 mm | |
3 | Structural Bulb Rivet, 6.5 mm | |
5 | Countersunk Rivet, 4.8 mm Long | |
11 | Countersunk Rivet, 4.8 mm Short |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the original component.
or Factory Spot Weldsor Drill through factory spot weldsNoteWhen drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
-
Prepare for installation.
NoteA red X indicates a location where a factory-installed fastener is not being replaced.
or Structural Bulb Rivets, 6.5 mm
or Countersunk Rivets, 4.8 mm Short
or Structural Countersunk Rivets, 6.5 mm
or Countersunk Rivets, 4.8 mm Long
or Installation Spot Welds
NoteSome rivet installation locations have been offset to avoid locations where removed fasteners are not being replaced. - Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Perform resistance spot
welding.
or Installation Spot WeldsWarningFailure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.CAUTIONDo not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
-
Cut the butyl foil patch and
cover the installed rivets as shown.
- Perform any necessary post-repair operations.