2026-04-10

Parcel Shelf Crossmember Assembly (Without Center Trough)

Correction code: 10101917902 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair work required to perform this procedure, including the linked Collision Repair procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Add any associated mechanical procedures needed to perform this procedure.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	ASSEMBLY - PARCEL SHELF CROSSMEMBER (Parcel Shelf Crossmember Assembly)
34	Structural Bulb Rivet, 6.5 mm
2	High Strength Structural Rivet, 6.5 mm
2	Rivet, 4.8 mm
4	Flow Form Rivet S18

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Trunk (Remove and Install).
Remove the Garnish - Trunk (Remove and Replace).
Remove the Front Carpet - Rear Trunk (Remove and Replace).
Remove the Trim - Side - Trunk - LH (Remove and Replace).
Remove the Glass - Backlight (Remove and Replace).
Remove the Amplifier - Audio - External (Remove and Replace).
Remove the Woofer - Parcel Shelf (Remove and Replace).
Remove the Retractor - Seatbelt - 2nd Row - Outboard (Single Side) (Remove and Replace).
Remove the Rear Center Trough.
Remove the original component.
or Factory Spot Welds
or Factory SPRs

or Drill through factory spot welds
Note
When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
Prepare for installation.
or High Strength Structural Rivets, 6.5 mm
or Structural Bulb Rivets, 6.5 mm

or Rivets, 4.8 mm

or Flow Form Rivets, S18
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Install the Rear Center Trough.
Install the Retractor - Seatbelt - 2nd Row - Outboard (Single Side) (Remove and Replace).
Install the Woofer - Parcel Shelf (Remove and Replace).
Install the Amplifier - Audio - External (Remove and Replace).
Install the Glass - Backlight (Remove and Replace).
Install the Trim - Side - Trunk - LH (Remove and Replace).
Install the Front Carpet - Rear Trunk (Remove and Replace).
Install the Garnish - Trunk (Remove and Replace).
Install the Trunk (Remove and Install).