2026-04-10

Trunk Floor Assembly (Side Panel)

Correction code: 10101811102 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Parts List

Quantity Description Image / Notes
1 ASY - TRUNK FLOOR (Trunk Floor Assembly)
17 Rivet, 4.8 mm

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

  1. Remove the Bumper Beam - Rear (Remove and Replace).
  2. Remove the Front Carpet - Rear Trunk (Remove and Replace).
  3. Remove the Trim - Side - Trunk - LH (Remove and Replace).
  4. Remove the original component.

    or Factory Spot Welds

    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    Note
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
  5. Remove the new component from the service part to make the new component.
    Refer to the previous step for fastener removal information.
    Informational PurposesAn informational icon, calling your attention
    Note
    Removing the LH component from the service part is shown, but removing the RH component is similar.
  6. Prepare for installation.

    or Rivets, 4.8 mm

  7. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  8. Install the new component or components.
  9. Perform any necessary post-repair operations.
  10. Install the Trim - Side - Trunk - LH (Remove and Replace).
  11. Install the Front Carpet - Rear Trunk (Remove and Replace).
  12. Install the Bumper Beam - Rear (Remove and Replace).