Rear Damper Mount Upper
Correction code:
10101905902
10101906002
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 |
ASY, RR DAMPER MT UPR (Rear Damper Mount - Upper) |
|
| 16 | High Strength Structural Rivet, 6.5 mm |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- Remove the Diffuser - Rear Fascia (Remove and Replace).
- Remove the Wheel Arch Liner - Rear - LH (Remove and Replace).
- Remove the Damper - Rear - LH (Remove and Replace).
- Remove the Link - Aft - Lower - Rear - LH (Remove and Replace).
- Remove the Link - Fore - Lower - Rear - LH (Remove and Replace).
- Remove the Link - Aft - Upper - Rear - LH (Remove and Replace).
- Remove the Link - Fore - Upper - Rear - LH (Remove and Replace).
- Remove the Link - Fore - Upper - Rear - RH (Remove and Replace).
- Remove the Toe link - Rear - LH (Remove and Replace).
- Remove the Trim - Side - Trunk - LH (Remove and Replace).
- Remove the Busbar - Charge Port to HV Battery (China) (Remove and Replace).
-
Remove the original component.
or Factory Spot Welds
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- Perform any necessary post-repair operations.
- Install the Busbar - Charge Port to HV Battery (China) (Remove and Replace).
- Install the Trim - Side - Trunk - LH (Remove and Replace).
- Install the Toe link - Rear - LH (Remove and Replace).
- Install the Link - Fore - Upper - Rear - RH (Remove and Replace).
- Install the Link - Fore - Upper - Rear - LH (Remove and Replace).
- Install the Link - Aft - Upper - Rear - LH (Remove and Replace).
- Install the Link - Fore - Lower - Rear - LH (Remove and Replace).
- Install the Link - Aft - Lower - Rear - LH (Remove and Replace).
- Install the Damper - Rear - LH (Remove and Replace).
- Install the Wheel Arch Liner - Rear - LH (Remove and Replace).
- Install the Diffuser - Rear Fascia (Remove and Replace).