2025-08-06

Rear Jack Pad Bracket

Correction code: 10102902702 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair work required to perform this procedure, including the linked Collision Repair procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Add any associated mechanical procedures needed to perform this procedure.

Repair Procedure

  1. Remove the necessary portion of the Body Side Outer to expose the underlying component being replaced.
  2. Remove the original component.

    or Factory Spot Welds

  3. Prepare for installation.
  4. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  5. Install the new component or components.
  6. Install the necessary portion of the Body Side Outer that was removed to expose the component being replaced.
  7. Install the fasteners as indicated.
  8. Perform any necessary post-repair operations.