2026-04-10

Heelboard Crossmember (Rear)

Correction code: 10101800102 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	ASY - CROSSMEMBER HEELBOARD REAR (Heelboard Crossmember - Rear)
12	Rivet, 4.8 mm
2	Countersunk Rivet, 4.8 mm Long
8	Countersunk Rivet, 4.8 mm Short

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Foam - Seat Back - 2nd Row - RH (Remove and Replace).
Remove the Carpet - Rear (Remove and Replace).
Remove the HV Battery (RWD) (Remove and Replace).
Remove the Heelboard Crossmember (Front).
Remove the original component.

or Factory Spot Welds
Prepare for installation.

Note
A red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.

or Rivets, 4.8 mm
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Install the Heelboard Crossmember (Front).
Install the fasteners as indicated.
or Countersunk Rivets, 4.8 mm Short
or Countersunk Rivets, 4.8 mm Long
- A = 12 mm.
- B = 27 mm.
Perform any necessary post-repair operations.
Install the HV Battery (RWD) (Remove and Replace).
Install the Carpet - Rear (Remove and Replace).
Install the Foam - Seat Back - 2nd Row - RH (Remove and Replace).