2026-04-10

Parcel Shelf Extension (Rear)

Correction code: 10101907902 10101908002 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	EXTN, PARCEL SHELF RR (Parcel Shelf Extension - Rear)
10	Structural Bulb Rivet, 6.5 mm
2	Countersunk Rivet, 4.8 mm Short
1	Structural Countersunk Rivet, 6.5 mm
1	Flow Form Rivet S18

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Busbar - Charge Port to HV Battery (China) (Remove and Replace).
Remove the ECU - Charge Port (Gen4) (Remove and Replace).
Remove the Door Assembly - Charge Port (NA) (Remove and Replace).
Remove the Garnish - Trunk (Remove and Replace).
Remove the Front Carpet - Rear Trunk (Remove and Replace).
Remove the Trim - Side - Trunk - LH (Remove and Replace).
Remove the Tub Carpet - Rear Trunk (Remove and Replace).
Remove the Glass - Backlight (Remove and Replace).
Remove the Amplifier - Audio - External (Remove and Replace).
Remove the Woofer - Parcel Shelf (Remove and Replace).
Remove the Retractor - Seatbelt - 2nd Row - Outboard (Single Side) (Remove and Replace).
Remove the Trunk (Remove and Install).
Remove the Hinge - Power Trunk - LH (Remove and Replace).
Remove the original component.

or Factory Spot Welds

or Factory SPRs
Remove any remaining adhesive from the mating surfaces of the vehicle.
Prepare for installation.

Note
A red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.

or Structural Bulb Rivets, 6.5 mm

or Countersunk Rivets, 4.8 mm Short

or Structural Countersunk Rivets, 6.5 mm

or Flow Form Rivets, S18
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Perform any necessary post-repair operations.
Install the Hinge - Power Trunk - LH (Remove and Replace).
Install the Trunk (Remove and Install).
Install the Retractor - Seatbelt - 2nd Row - Outboard (Single Side) (Remove and Replace).
Install the Woofer - Parcel Shelf (Remove and Replace).
Install the Amplifier - Audio - External (Remove and Replace).
Install the Glass - Backlight (Remove and Replace).
Install the Tub Carpet - Rear Trunk (Remove and Replace).
Install the Trim - Side - Trunk - LH (Remove and Replace).
Install the Front Carpet - Rear Trunk (Remove and Replace).
Install the Garnish - Trunk (Remove and Replace).
Install the Door Assembly - Charge Port (NA) (Remove and Replace).
Install the ECU - Charge Port (Gen4) (Remove and Replace).
Install the Busbar - Charge Port to HV Battery (China) (Remove and Replace).