Rear Wheelhouse Reinforcement
Correction code:
10101911102
10101911602
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair work required
to perform this procedure, including the linked Collision
Repair procedures. Do not stack Collision Repair
correction codes unless explicitly told to do
so. Add any associated mechanical procedures
needed to perform this procedure.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
Quantity | Description | Image / Notes |
---|---|---|
1 | PNL REAR WHEELHOUSE REINF CLOSEOUT (Rear Wheelhouse Reinforcement) | |
7 | Rivet, 4.8 mm | |
2 | Structural Bulb Rivet, 6.5 mm |
Repair Procedure
-
Remove the necessary portion
of the Body Side Outer to expose the underlying component being replaced.
-
Remove the original component.
or Factory Spot Weldsor Drill through factory spot weldsNoteWhen drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
or Factory SPRs
-
Prepare for installation.
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Install the necessary
portion of the Body Side Outer that was removed to
expose the component being replaced.