2026-04-10

Rear Subframe Crossmember (Lower)

Correction code: 10101811702 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Parts List

Quantity Description Image / Notes
1 ASY, CROSSMEMBER, RR SUBFRAME LWR (Rear Subframe Crossmember – Lower)
10 High Strength Structural Rivet, 6.5 mm
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

  1. Remove the Bumper Beam - Rear (Remove and Replace).
  2. Remove the Trim - Trunk Sill (Remove and Replace).
  3. Remove the Carpet - Rear (Remove and Replace).
  4. Remove the Front Carpet - Rear Trunk (Remove and Replace).
  5. Remove the Trim - Side - Trunk - LH (Remove and Replace).
  6. Remove the Trim - Side - Trunk - LH (Remove and Replace).
  7. Remove the Subframe Assembly - Rear (Remove and Replace).
  8. Remove the Rear Subframe Crossmember (Upper).
  9. Remove the original component.
    Factory SPR
  10. Prepare for installation.

    High Strength Structural Rivet, 6.5 mm

  11. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  12. Install the new component or components.
  13. Install the Rear Subframe Crossmember (Upper).
  14. Perform any necessary post-repair operations.
  15. Install the Subframe Assembly - Rear (Remove and Replace).
  16. Install the Trim - Side - Trunk - LH (Remove and Replace).
  17. Install the Trim - Side - Trunk - LH (Remove and Replace).
  18. Install the Front Carpet - Rear Trunk (Remove and Replace).
  19. Install the Carpet - Rear (Remove and Replace).
  20. Install the Trim - Trunk Sill (Remove and Replace).
  21. Install the Bumper Beam - Rear (Remove and Replace).