2026-04-10

Front Seat Mount Reinforcements (Front Inboard and All Rear)

Correction code: 10101028202 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Parts List

Quantity Description Image / Notes
1 ASY – FSF SEAT MOUNT REINF (Front Seat Mount Reinforcement – Front and Rear Outboard)
Informational PurposesAn informational icon, calling your attention
Note
This part replaces all Front Seat Mount Front reinforcements and the Front Seat Mount Rear Outboard reinforcements. It does not replace the Front Seat Mount Rear Inboard reinforcements.
1 MY ASY – REINF FSR CROSSMEMBER INBOARD SVC E-COATED (Front Seat Mount Reinforcement – Rear Inboard)
Informational PurposesAn informational icon, calling your attention
Note
This part replaces only the Front Seat Mount Rear Inboard reinforcements: it does not replace the Front Seat Mount Front reinforcements or the Front Seat Mount Rear Outboard reinforcements.
1 M3 FLOOR PANEL PATCH

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

  1. Remove the Center Console (Remove and Replace).
  2. Remove the Carpet - Front - LH (Remove and Replace).
  3. Remove the Carpet - Front - RH (Remove and Replace).
  4. Remove the Carpet - Rear (Remove and Replace).
  5. Remove the HV Battery (RWD) (Remove and Replace).
  6. For the Seat Mount Reinforcement being replaced, cut a hole in the underside of the floor panel to access the damaged component.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not cut the floor panel under any mount that is not being replaced.
    Informational PurposesAn informational icon, calling your attention
    Note
    Do not damage the floor cross members when cutting the floor panel.
    Reference Line/Point
    • A = 564 mm.
    • B = 623 mm.
    • C = 503 mm.
    • D = 563 mm.
    • E = 433 mm.
    • F = 561 mm.
    • G = 501 mm.
    • H = 127 mm.
    • I = 67 mm.
  7. Remove the original component.

    or Factory Spot Welds

  8. Cut the floor panel patch as indicated below to make a cover for the floor panel repair area.

    Cut Line

    Reference Line/Point

    • J = 78 mm.
  9. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    New components are installed with structural adhesive only.
  10. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  11. Install the new component or components.
    Informational PurposesAn informational icon, calling your attention
    Note
    Temporarily secure the Seat Mount Reinforcement to the underside of the crossmember using a bolt or a clamp until the structural adhesive has cured.
  12. Install a floor panel patch over the access window.
  13. Perform any necessary post-repair operations.
  14. Install the HV Battery (RWD) (Remove and Replace).
  15. Install the Carpet - Rear (Remove and Replace).
  16. Install the Carpet - Front - RH (Remove and Replace).
  17. Install the Carpet - Front - LH (Remove and Replace).
  18. Install the Center Console (Remove and Replace).