2026-07-20
Door - Front - LH (Remove and Install)
校正代码
10106001
0.42
注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。
注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。
注意：请参阅人员保护，确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。注意：请参阅查看安全健康的作业规程。
拆卸
- Remove the 2nd row lower seat cushion. See Seat Cushion - Lower - 2nd Row (Remove and Replace).
- Remove the rear underhood apron. See Underhood Apron - Rear (Remove and Replace).
- Disconnect 12V power. See 12V/LV Power (Disconnect and Connect).
- Remove the LH instrument panel end cap. See End Cap - Instrument Panel - LH (Remove and Replace).
- Remove the middle A-Pillar trim panel. See Trim - A-Pillar - Middle - LH (Remove and Replace).
- Remove the LH lower A-pillar trim. See Trim - A-Pillar - Lower - LH (Remove and Replace).
-
Disconnect the LH front door
electrical connectors from the LH body controller module.
-
Release the electrical
harness clip from the LH body controller module.
-
Release the grommet, and
then push the LH door electrical harness through the A-pillar
bulkhead.
-
Remove the bolt that
attaches the LH front door check strap to the A-pillar.
24 Nm (17.7 lbs-ft)CAUTIONUnbolting the door check allows the door to swing freely beyond opening limits. -
Use tape to mark the
mounting locations of the door hinges on the LH front door.
-
Loosen the hinge bolts, and
then remove the lower bolts for each hinge.
24 Nm (17.7 lbs-ft) -
Partially unthread the
upper bolt for each hinge, and with assistance, lift the LH front door away
from the vehicle.
安装
安装程序与拆卸程序相反，以下各项除外：
- Partially thread the upper bolt for each hinge in the door so that the door can set on the hinges to install the lower bolt.
- Apply touch up paint to painted fasteners that were removed and reinstalled during this procedure.