2026-07-20

Condenser (Remove and Replace)

校正代码 18201002 2.70 注意：除非本程序中另有明确规定，否则上述校正代码和 FRT 反映的是执行本程序（包括关联程序）所需的所有工作。除非明确要求，否则请勿堆叠校正代码。 注意：请参阅平均维修工时，深入了解 FRT 及其创建方式。 注意：请参阅人员保护，确保在执行以下程序时穿戴适当的个人防护装备 (PPE)。注意：请参阅查看安全健康的作业规程。

Informational PurposesAn informational icon, calling your attention
Note
This procedure requires the A/C Refrigerant (Recovery and Recharge) procedure to be performed. If not already automatically added to the Service Visit, add correction code 18200102 as a separate correction within the same activity to the Service Visit.

拆卸

  1. Remove the cooling fan module. See Module - Cooling Fan (Remove and Install).
  2. Release the clips (x14) that attach the active grille shutter to the cooling fan module, and then remove the active grille shutter from the module.
  3. Remove the screws (x2) that attach the radiator to the cooling fan module.
    10 Nm (7.4 lbs-ft)
  4. Release the clip that attaches the radiator to the cooling fan module, and then remove the radiator from the cooling fan module.
  5. Release the clips (x2) that attach the condenser to the cooling fan module, and then remove the condenser from the cooling fan module.

安装

安装程序与拆卸程序相反。