2026-08-09

Sensor - Impact Accelerometer - B-Pillar - LH (Remove and Replace)

Correction code 2020010612 FRT 0.30 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See to learn more about FRTs and how they are created. NOTE: See Personal Protection to make sure you are wearing proper PPE when performing the procedure below. NOTE: See for safe and healthy working practices.

Warning
Make sure 12V/LV power has been disconnected for at least 1 minute before disconnecting the electrical harness from Supplementary Restraint System (SRS) components, such as Restraint Control Module, sensors, airbags, etc. Disconnect the 12V/LV battery and the First Responder Loop. Failure to do so can result in unintended safety system behaviors. For more information on SRS precautions, see .

Remove

  1. Remove the LH 2nd row seat side bolster. See Bolster - Side - Seat - 2nd Row - LH (Remove and Replace).
  2. Remove the 2nd row lower seat cushion. See .
  3. Remove the LH instrument panel end cap. See .
  4. Remove the LH lower A-pillar trim. See .
  5. Remove the LH lower B-pillar trim. See Trim - B-Pillar - Lower - LH (Remove and Replace).
  6. Remove the LH middle B-pillar trim. See Trim - B-Pillar - Middle - LH (Remove and Replace).
  7. Disconnect the electrical connector from the LH B-pillar impact accelerometer sensor.
    Note
    Pull the red tab away to disengage the lock, then pull to disconnect the connector.
  8. Remove the bolt that attaches the LH B-pillar impact accelerometer sensor to the body, then remove the sensor.
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm 12-point deep socket
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench (for installation only)

Install

  1. Install the bolt that attaches the LH B-pillar impact accelerometer sensor to the body.
    8 Nm (5.9 lbs-ft)
    Tip
    Use of the following tool(s) is recommended:
    • 10 mm 12-point deep socket
    • Cordless Ratchet/Impact Driver
    • Ratchet/torque wrench (for installation only)
  2. Connect the electrical connector to the LH B-pillar impact accelerometer sensor.
  3. Install the LH middle B-pillar trim. See Trim - B-Pillar - Middle - LH (Remove and Replace).
  4. Install the LH lower B-pillar trim. See Trim - B-Pillar - Lower - LH (Remove and Replace).
  5. Install the LH lower A-pillar trim. See .
  6. Install the LH instrument panel end cap. See .
  7. Install the 2nd row lower seat cushion. See .
  8. Install the 2nd row seat side bolster. See Bolster - Side - Seat - 2nd Row - LH (Remove and Replace).