2024-07-10

C 柱加固件

Repair Procedure

  1. 拆下围板外壳。
  2. Remove the original component.

    or Factory Spot Welds

    or Factory SPRs

  3. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or Structural Rivets, 6.5 mm Short

    or Flow Form Rivets, S08

    or Flow Form Rivets, S28

  4. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or Structural Rivets, 6.5 mm Short

    or Flow Form Rivets, S08

    or Flow Form Rivets, S28

  5. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  6. Install the new component or components.
  7. 安装围板外壳。
  8. Perform any necessary post-repair operations.