2024-07-17

后节点上部加固件(后)

Parts List

Quantity Description Image / Notes
1 NODE CLOSEOUT REAR PANEL(后节点上部加固件(后))
4 Structural Flange Rivet
3

Bolt, hex-head M8-1.25x16

Tesla 零件号 1005582-00-A。
3 Nut HF M8X1.25 10-ZNAL-W Tesla 零件号 2007088。

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

  1. 拆卸后减震塔加固件(2014 年 11 月 5 日后制造的车辆)
  2. Remove the original component.
    or Factory Structural Rivets

    or Aluminum Plug Welds

    GMA Weld

  3. Prepare for installation.
  4. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  5. Install the new component or components.
    将这些螺栓拧紧至 25 Nm。
  6. Perform GMA welding.
    GMA Weld
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    To maintain vehicle crash integrity, use only approved welding wire and an approved GMA welder to perform GMA welding on Tesla vehicles. Refer to 已批准的气体保护金属极弧 (GMA) 焊接器和焊丝 for information on approved GMA welders and welding wire.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
    Informational PurposesAn informational icon, calling your attention
    Before GMA welding, a test weld using material of the same gauge and type should be performed to make sure that the welding equipment settings produce a satisfactory joint.
  7. 安装后减震塔加固件(2014 年 11 月 5 日后制造的车辆)
  8. Perform any necessary post-repair operations.