2024-07-17
前减震塔(所有双电机车辆以及所有 2016 年 4 月 10 日后制造的车辆)
Repair Information
- 根据该组件的损坏程度,有可能可以对该组件进行维修。请参阅 减震塔维修指南 了解更多信息。
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- Properly mount the vehicle on a frame bench when performing this procedure.
Parts List
Quantity | Description | Image / Notes |
---|---|---|
1 | ASM, SVC SHOCK TOWER-FR(前减震塔) |
![]() |
4 |
![]() |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- 拆卸前减震塔横梁。
- 拆卸前排座位外总成。
- 仅限左侧组件:拆卸前减震塔加固件 (LH)。
- 仅限右侧组件:拆卸 前电机支座(右)。
- Remove the original component.
-
Prepare for installation.
注A red X indicates a location where a factory-installed fastener is not being replaced.
or
Structural Rivets, 6.5 mm Medium
- A = 8 毫米。
- B = 46 毫米。
- C = 34 毫米。
- D = 30 毫米。
- Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Perform GMA welding.
警告Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.警告To maintain vehicle crash integrity, use only approved welding wire and an approved GMA welder to perform GMA welding on Tesla vehicles. Refer to 已批准的气体保护金属极弧 (GMA) 焊接器和焊丝 for information on approved GMA welders and welding wire.警告Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.注Before GMA welding, a test weld using material of the same gauge and type should be performed to make sure that the welding equipment settings produce a satisfactory joint.
- 仅限右侧组件:安装前电机支座(右)。
- 仅限左侧组件:安装前减震塔加固件 (LH)。
- 安装前排座位外总成。
- Install the fastener as indicated.
- 安装前减震塔横梁。
- Perform any necessary post-repair operations.