2024-07-10
轮罩外件(区块)- 带中国充电端口的车辆
Repair Information
- 本程序的Repair Procedure部分包含更换配备中国充电端口的车辆的轮罩外件后区块所需的信息。要更换配备中国充电端口的车辆的轮罩外件后区块,请使用轮罩外件(区块)- 不带中国充电端口的车辆程序。如果要更换整个轮罩外件(而非轮罩外件的后区块),请使用轮罩外件(整体)程序。
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
Quantity | Description | Image / Notes |
---|---|---|
1 | WHEEL ARCH OUTER PANEL(轮罩外件) |
![]() |
5 |
![]() |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
轮罩外件区块指南
- 如下所述,可以切开间隙孔或非功能孔(外饰孔)。
- 不要在螺柱中心 25 毫米范围内进行切割。
- 除非特别说明,否则区块不需要在对接接头或搭接接头处使用紧固件。
- 搭接和对接接头面板之间的间隙应尽可能小,以最大限度地提高接头强度。
- 密封所有外露的接缝。
Repair Procedure
- 拆下围板外壳 – 中国充电端口车辆,露出要更换的底层组件。
- Remove the original component.
- 切割新轮罩外件维修零件,以制作替换组件。
-
Prepare for installation.
注A red X indicates a location where a factory-installed fastener is not being replaced.
or
Structural Flange Rivets, 6.5 mm
警告轮罩外件的外侧边缘(轮罩外件表面与车身侧外件连接的位置)必须平坦,以正确装配上层车身侧外件组件。注更换区块的前边缘安装在车上该组件的后边缘下方,重叠至少 25 毫米。该接头仅使用结构型粘合剂固定。注本区块对接和搭接接头的相邻面板之间的间隙应尽可能小,以最大限度提高连接强度。 - Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- 安装先前为露出所更换组件而拆下的围板外壳 – 中国充电端口车辆部分。
- Perform any necessary post-repair operations.