2024-07-17

灯罩总成(非中国充电端口车辆)

Repair Procedure

  1. 拆下围板外壳 – 非中国充电端口车辆的必要部分,露出要更换的底层组件。
  2. Remove the original component.
    or Factory Spot Welds
    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
  3. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or Structural Bulb Rivets, 6.5 mm

    or Flow Form Rivets, S18

    or Flow Form Rivets, S28

  4. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  5. Install the new component or components.
  6. 安装先前为露出更换组件而拆下的围板外壳 – 非中国充电端口车辆的必要部分。
  7. Perform any necessary post-repair operations.