2024-07-17

车架前纵梁(2016 年 4 月 11 日至 2018 年 11 月 27 日生产的后轮驱动车辆以及 2018 年 11 月 27 日之前生产的所有双电机车辆)

Parts List

Quantity Description Image / Notes
1 ASY- MEMBER RAIL FR(车架前纵梁)
7 SPAC NUT,M8X2.8-3.5,STL[10] Tesla 零件号 1071915-00-A。
7 Bolt, Torx-head , BLT,BFLG,TRX,M8X27.0[10.9]-M-NP-08 Tesla 零件号 1022448-00-A。

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

  1. Remove the original component.
    原厂 BOM

    GMA Weld

  2. Prepare for installation.

    or Bolt, Torx-head

    GMA Weld

  3. 如果新车架前纵梁预先安装了 SPAC 螺母:从车架前纵梁适配器上拆下安装新 Torx 螺栓所需的材料。
  4. 如果新车架前纵梁未预先安装 SPAC 螺母:利用纵梁适配器上的现有孔作为模板,在车架前纵梁上制作 9 毫米孔。
  5. 如果新车架前纵梁未预先安装 SPAC 螺母:从车辆上拆下新组件,然后将车架前纵梁上的现有孔扩大到 11 毫米。
  6. 如果新车架前纵梁未预先安装 SPAC 螺母:在 SPAC 螺母内侧涂上结构型粘合剂,然后将其夹紧到位。
  7. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  8. Install the new component or components.
    将螺栓拧紧至 50 Nm。
  9. Perform GMA welding.

    GMA Weld

    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    To maintain vehicle crash integrity, use only approved welding wire and an approved GMA welder to perform GMA welding on Tesla vehicles. Refer to 已批准的气体保护金属极弧 (GMA) 焊接器和焊丝 for information on approved GMA welders and welding wire.
    Warning IconA warning icon, calling your attention to a possibly risky situation
    警告
    Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.
    Informational PurposesAn informational icon, calling your attention
    Before GMA welding, a test weld using material of the same gauge and type should be performed to make sure that the welding equipment settings produce a satisfactory joint.
  10. Perform any necessary post-repair operations.