2024-07-10

灯罩(2015 年 8 月 15 日之前制造的车辆)

Repair Procedure

  1. 拆下 围板外壳 – 非中国充电端口车辆 的必要部分,露出要更换的底层组件。
  2. Remove the original component.
    or Factory Spot Welds
  3. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or Structural Bulb Rivets, 6.5 mm

    or Flow Form Rivets, S18

    or Flow Form Rivets, S28

  4. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  5. Install the new component or components.
  6. 安装先前为更换组件而从 围板外壳 – 非中国充电端口车辆 拆下的必要部分。
  7. Perform any necessary post-repair operations.