2024-07-17

后备箱底板加长件(截至 2014 年 11 月 5 日制造的车辆)

Repair Information

Repair Procedure

  1. Remove the original component.
    or Factory Spot Welds

    or Factory Structural Rivets

  2. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or Structural Bulb Rivets, 6.5 mm

    or Structural Flange Rivets, 6.5 mm

    or SPRs, 5x4
    Informational PurposesAn informational icon, calling your attention
    以下 Tesla SPR 模具用于安装此 SPR:SM 070 0056
    or SPRs, 5x4.5
    Informational PurposesAn informational icon, calling your attention
    以下 Tesla SPR 模具用于安装此 SPR:KA 075 2113
    or SPRs, 5x6 H2
    Informational PurposesAn informational icon, calling your attention
    以下 Tesla SPR 模具用于安装此 SPR:SM 085 0125
  3. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  4. Install the new component or components.
  5. Perform any necessary post-repair operations.