2024-07-10
轮罩外件(整体)
Repair Information
- 本程序的 Repair Procedure 部分包含更换整个轮罩外件所需的信息。如果要更换轮罩外件的后区块(而非整个轮罩外件),请使用 轮罩外件(区块)- 不带中国充电端口的车辆 程序。
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
Quantity | Description | Image / Notes |
---|---|---|
1 | WHEEL ARCH OUTER PANEL(轮罩外件) |
![]() |
15 |
![]() |
|
6 |
![]() |
|
1 |
![]() |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
- 拆下C 柱加固件。
- Remove the original component.
-
Prepare for installation.
注A red X indicates a location where a factory-installed fastener is not being replaced.
or
Structural Bulb Rivets, 6.5 mm
or
SPRs, 5x5
注使用以下 Tesla SPR 模具安装此 SPR:KA 075 2113or
SPRs, 5x6 H2
注使用以下 Tesla SPR 模具安装此 SPR:SM 085 0125 - Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
-
Perform GMA welding.
GMA Weld
警告Failure to follow all welding safety precautions, including the use of personal protective equipment, could result in serious injury or property damage. Only technicians who have completed Tesla’s approved welding training are authorized to weld structural components on Tesla vehicles.警告To maintain vehicle crash integrity, use only approved welding wire and an approved GMA welder to perform GMA welding on Tesla vehicles. Refer to 已批准的气体保护金属极弧 (GMA) 焊接器和焊丝 for information on approved GMA welders and welding wire.警告Do not weld on a Tesla vehicle before performing the Vehicle Electrical Isolation Procedure (refer to the vehicle-specific Service Manual for more information on the Vehicle Electrical Isolation Procedure). Welding on a Tesla vehicle with an energized high or low voltage system might damage vehicle components.注Before GMA welding, a test weld using material of the same gauge and type should be performed to make sure that the welding equipment settings produce a satisfactory joint. - 安装C 柱加固件。
- Perform any necessary post-repair operations.