2026-11-05

Radhausverkleidung – Vorne – LH (Nicht Strukturpack)(Ausbauen und Ersetzen)

Korrekturcode 12010902 0.36 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Persönlicher Schutz to make sure wearing proper PPE when performing the below procedure. NOTE: See for safe and healthy working practices.

  • 2023-06-29: Added the whole procedure video as an overview for supplemental purposes only.
Equipment:
  • 1133569-00-A Zange, Clips entfernen

Ausbauen

  1. Remove the LH front wheel. See #GUID-0B862D15-7178-4435-AEF2-0B40B8BEE686.
  2. Raise vehicle fully and lower lift onto locks.
  3. Remove the bolt and clip that attaches the LH front wheel liner to the HV battery.
    5 Nm (3.7 lbs-ft)
    Note
    Es wird empfohlen, die folgenden Werkzeuge zu verwenden:
    • Steckschlüssel, 10 mm
  4. Remove the LH front fender garnish. .
  5. Release the clips (x14) that attach the LH front wheel arch liner to the vehicle, and then remove the liner from the vehicle.
    Note
    On certain vehicles, the RH wheel arch liner is secured by clips and a screw. If a screw is present, remove it with a Torx T30 socket.

Montieren

Beim Einbauverfahren werden die Schritte des Ausbauverfahrens in umgekehrter Reihenfolge ausgeführt.