2025-08-06

C–Pillar Reinforcement

Correction code: 10101913002 10101913102 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair work required to perform this procedure, including the linked Collision Repair procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Add any associated mechanical procedures needed to perform this procedure.

Repair Procedure

  1. Remove the Quarter Outer Skin.
    Refer to the procedure that is appropriate for the vehicle being repaired:
  2. Remove the original component.

    or Factory Spot Welds

    or Factory SPRs

  3. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or Structural Rivets, 6.5 mm Short

    or Flow Form Rivets, S08

    or Flow Form Rivets, S28

  4. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or Structural Rivets, 6.5 mm Short

    or Flow Form Rivets, S08

    or Flow Form Rivets, S28

  5. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  6. Install the new component or components.
  7. Install the Quarter Outer Skin.
    Refer to the procedure that is appropriate for the vehicle being repaired:
  8. Perform any necessary post-repair operations.