2026-08-10

Cowl Top (RHD Vehicles)

Correction code: 10101017702 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	ASSY - COWL TOP, SVC (Cowl Top – RHD Vehicles)
6	Structural Rivet, 6.5 mm Medium
46	Flow Form Rivet S18
4	Flow Form Rivet S38

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Hood Assembly (Remove and Install).
Remove the Fender Assembly - Front - LH (Remove and Install).
Remove the Panel - Cowl Screen (Remove and Replace).
Remove the Windshield (Remove and Install).
Remove the Noise Absorber - Motor Bay - Front (Pre-Refresh) (Remove and Replace).
Remove the Assembly - Top Pad - Instrument Panel (Remove and Install).
Remove the original component.
or Factory Spot Welds
or Drill through factory spot welds
Note
When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
Prepare for installation.

or Structural Rivets, 6.5 mm Medium

or Flow Form Rivets, S18

or Flow Form Rivets, S38
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Perform any necessary post-repair operations.
Install the Assembly - Top Pad - Instrument Panel (Remove and Install).
Install the Noise Absorber - Motor Bay - Front (Pre-Refresh) (Remove and Replace).
Install the Windshield (Remove and Install).
Install the Panel - Cowl Screen (Remove and Replace).
Install the Fender Assembly - Front - LH (Remove and Install).
Install the Hood Assembly (Remove and Install).