Cowl to Shock Tower Brace Reinforcement
Correction code:
10101018002
NOTE:
Unless explicitly stated in the procedure, the above
correction code includes all Collision Repair and Service
repair work required to perform this procedure, including
the linked Collision Repair procedures and linked Service
procedures. Do not stack Collision Repair correction
codes unless explicitly told to do so. Depending
on the damage to the vehicle, additional repairs may be
required.
Repair Information
- Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
- This procedure can be completed without using a frame bench.
Parts List
| Quantity | Description | Image / Notes |
|---|---|---|
| 1 | ASY-REINF-SHOCKTWR BRACE MTG (Cowl to Shock Tower Brace Reinforcement – Upper) | |
| 6 | Structural Rivet, 6.5 mm Short | |
| 5 | SPR, 5x4.5 | |
| 2 | SPR, 5x7 |
When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.
Repair Procedure
-
Remove the original component.
or Factory Spot Welds
-
Prepare for installation.
or Structural Rivets, 6.5 mm Short
or SPRs, 5x4.5NoteUse the following Tesla SPR die to install this SPR: FM 090 2120.or SPRs, 5x7NoteUse the following Tesla SPR die to install this SPR: FM 090 2120. - Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
- Install the new component or components.
- Perform any necessary post-repair operations.