2026-06-09

Rear Panel Assembly

Correction code: 10101817102 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Parts List

Quantity Description Image / Notes
1 REAR COMPLETE BODY PANEL
46 Structural Bulb Rivet, 6.5 mm
4 Flow Form Rivet S38
16 Bolt, hex-head , M10x25 Tesla part number 2007069. (Rear Rail to Rear Panel)
8 Washer Tesla part number 1024072-00-A. (Rear Rail to Rear Panel)
Informational PurposesAn informational icon, calling your attention
Note
Only for vehicles without third row seats. If necessary, use with Tesla part number 1047337-00-A.
8 Nut , M10x1.5 Tesla part number 1006883-00-A. (Bumper Beam to Rear Panel)

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

  1. Remove the original component.

    or Factory Spot Welds

    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    Note
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.

    or Factory Structural Rivets

    Stud
  2. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    A red X indicates a location where a factory-installed fastener is not being replaced. Secure this location using structural adhesive only.

    Reference Line/Point

    or Structural Bulb Rivets, 6.5 mm A = 9 mm B = 145 mm C = 55 mm

    or Flow Form Rivets, S38

    or Bolts, hex-head

  3. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  4. Install the new component or components.
    Tighten the nuts, but do not torque them at this time. These nuts are torqued when the bumper assembly is installed.
  5. Perform any necessary post-repair operations.