2025-08-06

Lamp Housing Assembly (Non-China Charge Port Vehicles)

Correction code: 10100104202 10100104502 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair work required to perform this procedure, including the linked Collision Repair procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Add any associated mechanical procedures needed to perform this procedure.

Repair Procedure

  1. Remove the necessary portion of the Quarter Outer Skin – Non-China Charge Port Vehicles to expose the underlying component being replaced.
  2. Remove the original component.
    or Factory Spot Welds
    or Drill through factory spot welds
    Informational PurposesAn informational icon, calling your attention
    Note
    When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
  3. Prepare for installation.
    Informational PurposesAn informational icon, calling your attention
    Note
    A red X indicates a location where a factory-installed fastener is not being replaced.

    or Structural Bulb Rivets, 6.5 mm

    or Flow Form Rivets, S18

    or Flow Form Rivets, S28

  4. Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
  5. Install the new component or components.
  6. Install the necessary portion of the Quarter Outer Skin – Non-China Charge Port Vehicles that was removed to expose the component being replaced.
  7. Perform any necessary post-repair operations.