2026-02-21

Quarter Outer (Lower Section)

Correction code: pending NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair work required to perform this procedure, including the linked Collision Repair procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Add any associated mechanical procedures needed to perform this procedure.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	REAR QUARTER PANEL OUTER (Rear Quarter Panel Outer)	Tesla part number 6006695-S0-E.
18	Flow Form Rivet S08
14	Structural Bulb Rivet, 6.5 mm

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the Quarter Outer (Lower Section) from the Quarter Outer Skin.
Reference Line/Point

Cut Line
- A = 41 mm
Remove the original component.
Reference Line/Point
Cut Line
- A = 41 mm
- B = 67 mm
or Factory Spot Welds

or Drill through factory spot welds

Note
When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.
Prepare for installation.

Note
Install the Quarter Outer (Lower Section) under the Quarter Outer.

Note
Enlarge the bumper attachment bracket holes.

Note
A red X indicates a location where a factory-installed fastener is not being replaced.

or Structural Bulb Rivets, 6.5 mm

or Flow Form Rivets, S08
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Perform any necessary post-repair operations.