2025-08-06

Rear Seat Floor Panel Section

Correction code: 10101817002 NOTE: Unless explicitly stated in the procedure, the above correction code includes all Collision Repair and Service repair work required to perform this procedure, including the linked Collision Repair procedures and linked Service procedures. Do not stack Collision Repair correction codes unless explicitly told to do so. Depending on the damage to the vehicle, additional repairs may be required.

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	PNL - RR FLOOR SEAT (REFRESH) (Rear Seat Floor Panel)
9	Structural Bulb Rivet, 6.5 mm

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Cut the new Rear Seat Floor Panel to make the new component.
Cut Line

Reference Line/Point
- A = 170 mm.
Remove a section of the original component.
Cut Line
Reference Line/Point
- B = 130 mm.
or Factory SPRs
Prepare for installation.
or Structural Bulb Rivets, 6.5 mm
Cut Line

Reference Line/Point
- C = 194 mm
- D = 7 mm
- E = 74 mm
- F = 99 mm
- G = 10 mm
- H = 6 mm
- I = 179 mm
- J = 91 mm
- K = 103 mm
- L = 163 mm
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
Perform any necessary post-repair operations.