2026-08-09

Radhausverkleidung – Hinten – LH (Nicht Strukturpack) (Ausbauen und Ersetzen)

Korrekturcode 12011102 0.24 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Persönlicher Schutz to make sure wearing proper PPE when performing the below procedure. NOTE: See for safe and healthy working practices.

Ausrüstung:
  • 1133569-00-A Zange, Clips entfernen
Warnung
The video(s) included in this procedure are meant as an overview for supplemental purposes only. Follow all of the steps listed in the procedure to avoid damage to components and/or personal injury.
  • 08.06.2023: Vollständiges Verfahrensvideo zur Übersicht nur als Ergänzung hinzugefügt.

Ausbauen

  1. Entfernen Sie das linke Hinterrad. Siehe .
  2. Lösen Sie die 16 Clips, mit denen die hintere LH Radhausverkleidung am Fahrzeug befestigt ist, und entfernen Sie dann die Verkleidung vom Fahrzeug.

Montieren

Beim Einbauverfahren werden die Schritte des Ausbauverfahrens in umgekehrter Reihenfolge ausgeführt.