2026-11-05
Revestimiento del paso de la rueda - Parte delantera - Lado izquierdo (Sin paquete estructural)(Desinstalación y sustitución)
Código de corrección
12010902 0.36
NOTE: Unless otherwise explicitly
stated in the procedure, the correction code and its associated FRT reflect all of the
work required to perform this procedure, including the linked procedures. Do not stack correction codes unless
explicitly told to do so.
NOTE: See Flat Rate
Times to learn more about FRTs and how they are created.
NOTE: See Protección personal to make sure wearing proper PPE when
performing the below procedure. NOTE: See for safe and healthy working
practices.
- 2023-06-29: Added the whole procedure video as an overview for supplemental purposes only.
Equipment:
- 1133569-00-A Alicates, extracción de clips
Especificaciones de apriete
| Descripción | Valor de apriete | Herramientas recomendadas | Reutilizar/Sustituir | Notas |
|---|---|---|---|---|
| Perno que fija el revestimiento de la rueda delantera izquierda a la batería de alta tensión |
 5 Nm (3.7 lbs-ft) |
|
Reutilizar |
Retirar
- Remove the LH front wheel. See #GUID-0B862D15-7178-4435-AEF2-0B40B8BEE686.
- Raise vehicle fully and lower lift onto locks.
-
Remove the bolt and clip
that attaches the LH front wheel liner to the HV battery.5 Nm (3.7 lbs-ft)NoteSe recomienda utilizar las siguientes herramientas:
- Vaso de 10 mm
- Remove the LH front fender garnish. .
-
Release the clips (x14) that attach the LH front wheel
arch liner to the vehicle, and then remove the liner from the vehicle.
NoteOn certain vehicles, the RH wheel arch liner is secured by clips and a screw. If a screw is present, remove it with a Torx T30 socket.
Instalar
El procedimiento de instalación es inverso al de desmontaje.