2026-08-09

Defensa - Trasera - Superior (Desinstalación y sustitución)

Código de corrección 10012802 0.84 NOTE: Unless otherwise explicitly stated in the procedure, the correction code and its associated FRT reflect all of the work required to perform this procedure, including the linked procedures. Do not stack correction codes unless explicitly told to do so. NOTE: See Flat Rate Times to learn more about FRTs and how they are created. NOTE: See Protección personal to make sure wearing proper PPE when performing the below procedure. NOTE: See for safe and healthy working practices.

  • 2023-11-02: Added notes to distinguish between the steps for HW3/HW4 vehicles.

Especificaciones de apriete

Table 1. Especificaciones de apriete: Defensa - Trasera - Superior (Desinstalación y sustitución)
Descripción Valor de apriete Herramientas recomendadas Reutilizar/Sustituir Notas
Pernos (6 uds.) que sujetan la parte inferior de la defensa trasera a la parte superior de la defensa trasera
3 Nm (2.2 lbs-ft)
  • Vaso de 10 mm
 Reutilizar

Retirar

  1. Remove the rear fascia. See Defensa - Trasera (Desinstalación e instalación).
  2. For HW3 vehicles, release the connector locks (x2), and then disconnect the rear fascia harness connectors (x6).
    Note
    Skip this step for HW4 vehicles.
    Note
    Do not push down on the red locking tab. Pull the red tab to release the connector lock.
  3. For HW3 vehicles, remove the clips that attach the rear fascia harness to the upper rear fascia, and then remove the harness from the assembly.
    Note
    Skip this step for HW4 vehicles.
  4. Remove the bolts (x6) that attach the lower rear fascia to the upper rear fascia.
    3 Nm (2.2 lbs-ft)
    Tip
    Se recomienda utilizar las siguientes herramientas:
    • Vaso de 10 mm
  5. Remove the metal clips from the center of lower rear fascia.
  6. Release the tabs (x17) that attach the upper rear fascia to the lower rear fascia, and then separate the upper rear fascia from the lower rear fascia.
  7. Remove the rear parking distance sensors from the upper rear fascia for HW3 vehicles. See #GUID-57298231-B4D9-4589-AD7C-E82BBC397FD7.
    Note
    Skip this step for HW4 vehicles.

Instalar

El procedimiento de instalación es inverso al de desmontaje.