后行李箱底板加长件

Repair Information

Review all collision repair general practices and safety documentation and wear the appropriate PPE (Personal Protective Equipment) before beginning this procedure.
This procedure can be completed without using a frame bench.

Parts List


Quantity	Description	Image / Notes
1	EXTENSION - RR TRUNK FLOOR PNL（后行李箱底板加长件）
LH 组件：8 RH 组件：6	Structural Bulb Rivet, 6.5 mm
LH 组件：4 RH 组件：3	Rivet, 4.8 mm
3	Bolt, hex-head ，M8-1.25x20	Tesla 零件号 1007580-00-A。

When ordering parts, refer to the Parts Catalog and enter the VIN of the vehicle being repaired to find the correct parts (and the part numbers) for the vehicle. Alternatively, use the search function in the Parts Catalog to find a specific part for the vehicle.

Repair Procedure

Remove the original component.

or Factory Spot Welds

or Drill through factory spot welds
注
When drilling out spot welds, use a drill bit that creates a hole correctly sized for the fastener that will replace the spot weld.

or Bolts, hex-head
Prepare for installation.
注
A red X indicates a location where a factory-installed fastener is not being replaced.
or Structural Bulb Rivets, 6.5 mm
- A = 60 毫米。
- B = 11 毫米。
or Rivets, 4.8 mm

or Bolts, hex-head
Apply structural adhesive to the mating surfaces on the vehicle and the new component or components.
Install the new component or components.
将这些螺栓拧紧至 24 Nm。
Perform any necessary post-repair operations.